Control more things in your fleet by
connecting accessories and sensors to your Syrus device.
This accessory provides the SYRUS GPS tracking device with extra analog inputs that can be used in the same way the built-in Analog Input is used.
Use up to 8 single analog inputs
Up to 4 differential analog inputs or combined as needed
Water-proof and dust-proof casing
axle weight sensor
The Kimax 2 is an electronic weighing system integrated with Syrus
devices via the RS232 port. It can be used in all vehicles whose axles or
axle groups are equipped either with an air or steel spring suspension
system. Using Pegasus IoT Cloud fleet operators can visualize the
current load on all their truck’s axles and the total weight per
tractor/trailer in real time as well as set alerts/tiggers for any condition.
Current total load for the entire vehicle
Total weight per tractor/trailer
Alarm for overload on individual axles
The photo camera accessory connects to the Syrus via (RS-232) serial port (RX & TX cables) and takes photos based on any configurable event conditions. The camera is fully integrated with the Pegasus Gateway and its APIs allowing you to take low, medium, or high resolution photos based on multiple conditions.
Connect up to 3 cameras
& high resolution photos
High level APIs for taking & retrieving photos
Take photos upon request
ITEM #70031 / #70031
Syrus is compatible with 1-Wire communication technology therefore the Dallas Keys are simple and easy to configure and use as Driver Identification. Each key is coded with its unique number that can be scan by its matching receiver connected to the 1-wire cable included in the Syrus harness cable.
Syrus event engine configuration can validate up to 100 different ID pre-registered in the script and trigger any event depending if it is a valid and authorized key and can also scan all the possible Dallas Keys sending the unique coded information to the control center.
Easy to integrate into Syrus reporting script
Enables driver recognition & authorization
Validate up to 100 different keys
ECU MONITOR PLUS
The Engine Control Unit (ECU) Monitor Plus accessory is compatible with onboard vehicle computers that use CAN protocols (J1939/FMS), J1708/J1587, or OBDII. It comes with an RS-232 port for serial communication with third party device integration – this integration requires a Syrus Firmware plugin.
See how fuel is consumed on your fleet
View the engine data that helps analyze the health of your fleet
Read J1939/J1708/FMS & OBDII protocols
Compare up to 88+ engine parameters with non-engine related data
FUEL LEVEL SENSOR
DUT-E fuel level sensors are used for accurate fuel level and volume measurement in tanks of vehicles and stationary units. DUT-E allows you to determine current fuel volume and change in volume (refueling or draining) of fuel in the tank.
Monitoring of tank refueling and fuel draining
Fuel theft prevention
Fuel usage monitoring
FATIGUE WARNING SYSTEM
Fatigue warning systems like EyeAlert & CareDrive can be used to alert a driver as soon as he/she is falling asleep or not paying attention to the road for a determined period of time, protecting life and assets. It focuses entirely on the driver’s alertness levels or inattention to the road ahead regardless of the time of day or weather conditions. Making good drivers better because they now have positive immediate feedback that they need to act.
Driver Fatigue Alarm
Prevent pedestrian accidents
Over Speed Alarm
Driver Fatigue Video Output
The Vulcano is a flow meter sensor integrated with Syrus devices via RS232 port. It provides gasoline and diesel fuel measurement and shows the volume dispatched from the pump; specially design for portable pumps used by construction companies to feed their service vehicles. Using Pegasus IoT Cloud fleet operators can visualize and measure the amount of fuel each vehicles is using.
Garmin products are designed to help drivers and dispatchers improve customer response and optimize fleet resources with the goal of achieving lower costs and higher profits. These fleet-ready portable navigators are interactive navigation and messaging terminals that provide a fleet management interface (FMI). They serve as mobile data terminals and much more in PEGASUS.
APIs for messaging to Garmin terminals
Chat with drivers
This external accessory provides the SYRUS tracking device with extra inputs and outputs that can be used in the same way the built-in Input / Outputs are used. This accessory gives the Syrus a total of 7 ground-activated inputs, and 6 open drain outputs. The IO Expander is fully integrated with the Pegasus Gateway and its APIs.
Four (4) ground-activated inputs
Four (4) open drain outputs
ESD protection which supports up to 30V
Over temperature protection of 165C
RFID READER ACCESSORIES
SHORT RANGE READERS
RFID Short Range Reader
LONG RANGE READERS
RFID Long Range Reader
UFH Long Range Reader
MIC/SPEAKER AUDIO KIT
DCT hands-free device is specially designed to be wired directly to the Syrus tracking device harness cable and enables the fleet management control center to listen inside the vehicle cabin knowing exactly what is happening automatically after any event has been programmed to trigger the microphone.
Auto dialing mode
SERIAL PORT EXPANDER
The RS-232 3-PORT EXPANDER allows smart integrations for SYRUS with multiple serial connections for up to 3 external devices working simultaneously.
Photo Cameras – up to three (3)
Mobile Data Terminals (MDT)
SATCOM / Iridium Satellite Communicator
Weight Control Sensors
Mobileye, the advanced driver assistance solution chosen by leading auto manufacturers, uses an artificial vision sensor to view the road ahead and warn drivers with real-time visual and audible alerts if a threat is detected. The system performs advanced driver scene interpretations to identify other vehicles, bicyclists, pedestrians, lane markings, and speed limit signs, providing vital time to react and potentially avoid or mitigate a collision.
Hotspots where warnings occur more often
Comparative analysis of warnings per vehicle
Speed Limit Indicator
Lane Departure Warning
ITEM # 7000-6 MDAS-9/MFC10D
Add Syrus Actionable Telematics to Movon integrations and combine all Movon signals to Syrus Intelligent Event Reporting Engine. Use Pegasus Gateway managed configurations for easy setup and deployments.
Forward Proximity Warning (FPW)
Front Vehicle Start Alarm (FVSA)
Digital Video Recorder (DVR)
Lane Departure Warning
SATCOM IRIDIUM CONNECTIVITY
Satcom is an external Satellite Communicator accessory to enables Syrus tracking devices with Iridium’s truly global data network coverage. Plug & Connect compatible with Syrus GPS devices and easy to program and manage via Pegasus Gateway – web application – it’s the ideal solution for critical scenarios & activities that request reliable, near real-time, communication services without depending on a cellular network.
Global operating capability using the Iridium Satellite network
Fully programmable / configurable trigger
3G/GPRS with backup Satellite Network for data optimization
2-way communication with Pegasus Gateway
SYRUS BLUETOOTH TAG
A programmable IoT Smart Bluetooth Tag for stand-alone applications and expanded SYRUS 3G Bluetooth actionable intelligence. Fully supported by SYRUS Cloud-based APIs, ready for IoT interaction with Smart Ecosystems.
High Value Goods and Assets Monitoring
Cold Chain Temperature Monitoring
Driver Identification and Trailer-Truck Pairing
Syrus Sigfox communicator
The Syrus Sigfox is a radio communication accessory that enables Syrus GPS devices to
communicate globally with the first OG global network. Plug & Connect compatible with Syrus GPS devices, easy to program and manage in the Pegasus Cloud Gateway – web application. It is the ideal solution for critical scenarios and activities that request reliable, near real-time, communication services including backup for cellular networks.
RC2 and RC4 zone capability using the Sigfox RF network
Capable of event triggering using Syrus’ Jamming Detection
Fully programmable events using Syrus fixed signals
High gain, low-profile, external Sigfox *antenna
The temperature sensor is an accessory that allows up to 3 simultaneous temperature measurements with ± 0.4°C accuracy. Temperature thresholds can be established on the device’s configuration that allows you to combine with other conditions for highly customized event reporting.
Report temperature values
Establish thresholds and create events
Dashboard of your fleet’s temperature
View the temperature during a trip
Using the Syrus 3G devices and ECU Monitor accessory connected to Continental’s ContiPressureCheck, fleet operators have full control to manage tire pressures and temperatures at all times. Reduce the risk of failure while increasing mileage using Pegasus Gateway platform to control your fleet operation.
Receive immediate warnings when your tires are under inflated or overheating
System health check
Sense when a tire is removed and place an automated phone call
Using the Syrus 3G devices and ECU Monitor accessory connected to Doran’s 360™ Tire Pressure Monitoring Systems, Fleet Operators have full control to manage tire pressures and temperatures at all times. Reduce the risk of failure while increasing mileage using Pegasus Gateway platform to control your fleet operation.